Garage Epoxy Floor Covering - Concrete Floor Painting Ideas

Garage Epoxy Floor Covering

garage epoxy floor covering

  • Put or keep (a motor vehicle) in a garage

  • keep or store in a garage; "we don't garage our car"

  • an outbuilding (or part of a building) for housing automobiles

  • a repair shop where cars and trucks are serviced and repaired

  • Consisting of or denoting such a material

  • glue with epoxy; "epoxy the shards"

  • Epoxy or polyepoxide is a thermosetting polymer formed from reaction of an epoxide "resin" with polyamine "hardener". Epoxy has a wide range of applications, including fiber-reinforced plastic materials and general purpose adhesives.

  • a thermosetting resin; used chiefly in strong adhesives and coatings and laminates

garage epoxy floor covering - AeroMarine 300/21

AeroMarine 300/21 Epoxy Resin 1.5 Gallon Kit - with metering pumps

AeroMarine 300/21 Epoxy Resin 1.5 Gallon Kit - with metering pumps

Clear Epoxy Resin. Total yield of 1.5 Gallons. Consists of one gallon of #300 resin and 1/2 gallons of #21 Non Blushing Cycloaliphatic Hardener - (with metering pumps). Dries clear. Our best and most popular clear epoxy resin. It is ideal for most functions: Boat and aircraft building, poured countertops and general fiberglass and carbon fiber laminating. Great for building a 'Stitch and Glue' boat, Cedar strip kayak or canoe as well as for cold molded wood boat or fiberglass boats. This multifunctional epoxy is also used for pebble paving, pebble resurfacing, pebble repair, and pebble or stone decking. And automotive enthusiasts use it for laminating carbon fiber parts including hoods, dashes, etc. The 1.5, 3 and 6 gallon kits are available with handy metering pumps. It is also an excellent choice for poured epoxy countertops, bar tops and table tops; and even making Jewelry. The mix ratio is a simple 2:1 by either weight or volume. AeroMarine 300/21 is a thin, clear liquid. It has a working life of about 30 minutes, and sets hard in a few hours. Work life: 30 minutes@70F. Cure time: 24 hours@70F.

78% (16)

Tired Texture

Tired Texture

Recently we had our garage floor in the house coated in an epoxy coating, so that you could eat off it, if you had the desire.

This came with great effort, because we had to empty the entire contents of the double garage, which was considerable, and leave the cars outside for a week, while the worker bees did their thing.

The smell from the epoxy coating made our eyes glaze over, and all the onions in the kitchen automatically peeled themselves, but the end result is great.

After priming the concrete, a special undercoat was applied, in a colour appropriate to the top coat colour selected, and then boxs of small flakes (in our case, white with a hint of black) are then thrown across the wet surface until it is totally covered. The following day, the excess flakes are broomed off and separate coats of epoxy top coats are applied a day apart.

It makes a hard and clean attractive coating that is totally impervious to oil and water, so driving a wet car in leaves pools of water that doesn't soak in, so needing a quick mop. Fortunately this happens magically when my car is absent. ;-)

CGW Cabinets and Water Heater Encloser

CGW Cabinets and Water Heater Encloser

A set of 72" wall mounted CGW Cabinets and rubber cover molding on our custom coated floor. Note that we actually turned the hot water closet area into a funtional cabinet, plus the hot water equipment is now concealed and out of sight.

garage epoxy floor covering

Similar posts:

italian flooring design

glue down bamboo flooring

float floor

removing old vinyl flooring

laminate flooring polish

fabric floor

hardwood floor replacement

floor drain check valve

fitness floor mats

replacing hardwood floor planks

Category: None |Trackbacks(0) |Comments(0)

Post a comment

Only the blog author may view the comment.